Note: Although the cabling can be located outdoors, the UDM-Pro itself should be housed inside a protective enclosure. For outdoor applications, shielded Category 5 (or above) cabling should be used for all wired Ethernet connections and should be grounded through the AC ground of the power supply.For indoor applications, use Category 5 (or above) UTP cabling approved for indoor use.Standard-sized, 19 " wide rack with a minimum of 1U height available.Rack Mounting the UDM-Pro Installation Requirements Reinsert the tray into HDD bay and close the front panel tab. Remove all screws attaching the HDD's chassis to the tray, then remove the device. Open your UDM-Pro's front panel and pull out the HDD mounting tray. After a few seconds, the LED will turn off, and the device will automatically reboot.Ĭonnect the included Power Cord to the Power port.Įnsure that your UDM-Pro is fully powered down and unplugged prior to removing your HDD. Press and hold the Reset button for about 10 seconds until the display indicates that the device has reset itself. The device should be running after bootup is complete. By default, it is set to DHCP Server with the fallback IP address, 192.168.1.1/24. The SFP+ port supports a 1/10G Ethernet connection. The RJ45 port supports a 10/100/1000 Ethernet connection. By default, they are set to DHCP Server with the fallback IP address, 192.168.1.1/24. The RJ45 ports support 10/100/1000 Ethernet connections. Install a 3.5" or 2.5" HDD (not included) to use the device as an NVR for UniFi Protect. SFP+ Speed/Link/Activity LED (Ports 10 - 11) RJ-45 Speed/Link/Activity LED (Ports 1 - 9) The software will also display the location of the device on the map. This indicates that you clicked Locate in the UniFi Network Application. A display message of "UDM-Pro is Starting."
0 Comments
Leave a Reply. |